5. Wood industry
Mechanically ventilated hut dryers are very common in the wood industry, and include the following main types (figure 18 ):
one or two drying cells equipped with baffles (1) judiciously positioned to ensure correct air circulation and homogeneous drying;
one or more large-diameter helical fans (2) inside the dryer, blowing air over the entire height of the stacks perpendicular to the wood fibers;
an optional steam or water spray injection device. It is used for specific needs: humidification before drying of re-dried lumber with closed pores, surface humidification of lumber with defects when drying too quickly, generation of a very humid atmosphere at the start of drying...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference
This article is included in
Electricity networks and applications
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Wood industry
Bibliography
Heating element suppliers
ACIM JOUANIN S.A. [email protected]
CERHEC [email protected]
KANTHAL http://www.kanthal.com
RESCAL http://www.rescal.com
...Regulations
The Union technique de l'électricité (UTE) provides readers with collections of French, foreign and international standards, as well as reproductions of regulatory texts: both can also be purchased from the Association française de normalisation (AFNOR). In each country, the national standardization service can provide the same services.
Texts
- Textes officiels relatifs aux conditions techniques...
Standardization
- Installations électriques à haute tension : Règles - NF C 13-200 - 12-89
- High-voltage electrical installations – practical guide – determining conductor cross-sections and selecting protective devices - NF C 13-205 - 7-94
- Installations de branchement à basse tension : Règles - NF C 14-100 - 2-98
- Installations électriques à basse tension : Règles - NF C 15-100 - 12-02
- Installations électriques...
Electrical heating equipment market
2005 was marked by a sharp drop in the power ordered for thermal equipment, surpassing the increases of the previous two years: +6% between 2002 and 2003, +3% between 2003 and 2004, compared with -24% between 2004 and 2005.
Natural gas, which had grown significantly last year, with a 13-point gain in market share between 2004 and 2005, suffered the sharpest decline: -35% between...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference