6. Drawing up and using calibration certificates
When performing a calibration, it is advisable to draw up a measurement sheet for internal use, to ensure traceability of measurements. The following information should be recorded on this measurement sheet:
applicant identification ;
identification of the measuring chain or sensor to be calibrated ;
date of measurements ;
operator name ;
calibration method used ;
equipment used (temperature standard, bath, oven, multimeter, scanner, etc.) ;
immersion of standard and calibration sensors ;
raw measurement results.
This measurement sheet will be used to draw up the calibration...
The Ultimate Scientific and Technical Reference
This article is included in
Physical measurements
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Drawing up and using calibration certificates
Conclusion
Bibliography
Websites
International Temperature Scale of 1990 (ITS-90), available on the BIPM website :
http://www.bipm.org/utils/common/pdf/its-90/EIT-90.pdf
Guide to the Expression of Uncertainty in Measurement (JCGM 200:2008), available on the BIPM website :
Standards and norms
AFNOR
- Metrology – Application guide to NF EN ISO 10012 "Measurement management systems – Requirements for measuring processes and equipment". – Design, development, control and improvement of measurement or test processes. - FD X07-007 -
- Metrology – Tests – Metrology in the company – Measuring equipment verification report. - FDX07-011 -
- Metrology – Metrology in the company –...
The Ultimate Scientific and Technical Reference
