1. Hardware errors
1.1 In the design office
-
Drawing errors
These errors are very varied. They range from line errors in the sections and elevations shown, to poorly formed figures and incorrectly positioned dimension lines. They are often corrected at the execution stage (tracing) because of the incompatibilities they entail.
-
Calculation and similar errors
These are, for example, operation errors, formula errors, etc.
-
Transcription errors
For example, on the values of material characteristics, site assumptions and loadings.
The consequences of the last two types...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference
This article is included in
Pathologies and building rehabilitation
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Hardware errors
Standardization
- Produits laminés à chaud en aciers de construction non alliés. Conditions techniques de livraison. (= A 35-501). - [1] NF EN 10025 - 10-90
- Règles CM. Règles de calcul des constructions en acier. - [2] DTU P 22-701 - 12-66
- Règles de calcul des constructions en acier. Additif 1980. - [3] CTICM - 1981
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference