Overview
Français
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Roland D. WEILL: Engineer from École Polytechnique and École Nationale Supérieure de l'Armement - Professor Emeritus of Mechanical Engineering at the Israel Institute of Technology in Haifa (Israel)
INTRODUCTION
For the symbols and notations used on the figures, the reader is referred to the articles :
Dimensional, geometric and surface tolerances and deviations ;
Functional rating .
All dimensions given in the figures are in millimeters, unless otherwise indicated.
The Ultimate Scientific and Technical Reference
This article is included in
Material processing - Assembly
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Design of machining routines
Mechanical production function
References
Standardization
France
Association Française de Normalisation AFNOR
- Produits de fonderie. Tolérances dimensionnelles des pièces moulées. Surépaisseurs d'usinage (ISO 8062). - A 90-510 - 9-90
- Dessins techniques. Dessins d'opérations. Symbolisation des prises de pièces. - NF E 04-013 - 8-85
- Dessins techniques. Cotation et tolérancement. Cones. - NF E 04-557 - 12-91
- États de surface des produits. Moyens...
The Ultimate Scientific and Technical Reference
