Overview
Français
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHOR
-
Michel PASQUIER: Engineer from École Supérieure de l'Énergie et des Matériaux - CMD Gears and Reducers
INTRODUCTION
The tolerance system we will develop in this article complies with NF ISO 1328 standards and FD ISO/TR10064 technical reports from ISO technical committee 60 "Gears".
It applies only to cylindrical gears with involute profile teeth, and is limited to wheels with a diameter of 10,000 mm and a module of 70 mm.
Permissible deviations will be indicated by formulas (used for computer programs).
The system's reference rack is that of standard NF ISO 54.
This system specifies all the deviations that can be checked on an individual wheel or a complete gear, with the corresponding tolerances.
The Ultimate Scientific and Technical Reference
This article is included in
Mechanical and dimensional measurements
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Parallel gear control
Wheel housing check
Bibliography
Standardization
French and European standards
- Gears – Cylindrical gears – Information to be provided to the gear manufacturer. Classification index: E23-012. - NF E23-012 - 05-1986
- Déport des dentures des roues cylindriques pour engrenages extérieurs réducteurs et multiplicateurs. Indice de classement : E23-013-1. - E23-013-1 - 02-1993 ...
The Ultimate Scientific and Technical Reference
