1. Definitions

The notations and symbols used comply with XP E 03-110 Threads, Direct measurement methods.

The following definitions are taken from standards NF E 03-000 : Filetages, définitions des termes usuels, termes particuliers aux filetages triangulaires cylindriques et coniques and XP E 03-110 ...

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource.
Click here to request your free trial access!

Already subscribed? Log in!

The Ultimate Scientific and Technical Reference

A Comprehensive Knowledge Base, with over 1,200 authors and 100 scientific advisors

+ More than 10,000 articles and 1,000 how-to sheets, over 800 new or updated articles every year

From design to prototyping, right through to industrialization, the reference for securing the development of your industrial projects

This article is included in

Mechanical and dimensional measurements

This offer includes:

Knowledge Base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

Practical Path

Operational and didactic, to guarantee the acquisition of transversal skills

Doc & Quiz

Interactive articles with quizzes, for constructive reading

Subscribe now!

Ongoing reading
Definitions

Previous
page Estimate of uncertainty for thread-measurement standards

Diameter calculation on single thread flanks

References

(1) - AFNOR XP E 03-110. Décembre 2003 - Spécification géométrique des produits (GPS) – Filetage – Vérification par mesure directe - .
(2) - AFNOR NF E 03-000. Décembre 1985 - Filetages – Définitions des termes usuels. Termes particuliers aux filetages triangulaires,...