Overview
FrançaisABSTRACT
As it allows the simultaneous measurement of 3D positions, sizes and morpho-geometric characteristics of a particle stream, in-line digital holography is a reference optical interferometric technique for the characterization of multiphase flows. Until now, digital in-line holography was considered as a R&D technique, however, its relative simplicity and its growing success make it more and more accessible. In this article, the basic optical principles of the technique are exposed and formalized. Experimental and numerical implementation are discussed, from classical optical set-up to reconstruction methods, aswell as associated limits. Finally, the potential of digital in-line holography is illustrated by several examples of application.
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHORS
-
Fabrice LAMADIE: Engineer – researcher, HDR - CEA, DES, ISEC, DMRC, Univ. Montpellier, Marcoule, France
-
Loïc MÉÈS: Research Manager - CNRS, univ. Lyon, école centrale de Lyon, INSA Lyon, univ. Claude Bernard Lyon 1, LMFA, UMR5509, Écully, France
-
Corinne FOURNIER: Senior Lecturer, HDR - Univ. Lyon, UJM-Saint-Étienne, CNRS, Institut d'Optique Graduate School, Laboratoire Hubert Curien UMR 5516, Saint-Étienne, France
INTRODUCTION
Holography is a process for recording the phase and amplitude of a light wave diffracted by an object in the form of an interference pattern. In the online version, the wave used to illuminate objects also serves as a reference wave. This is known as "Gábor holography", in reference to the physicist Dénes Gábor (Denis Gabor), who expounded its principle in 1948. Historically, holograms were recorded on high-resolution photographic plates. Digital holography arose from the replacement of these plates by digital matrix sensors (CCD, CMOS) from the 2000s onwards, following the idea first proposed in 1967 by J. W Goodman and R. W Laurence. Very early on, the technique was applied to experimental fluid mechanics studies, enabling the size, position and velocity of moving particles in a flow to be measured with a simple experimental set-up. In the 2000s, its 3D character positioned it as a promising alternative to tomographic methods of particle image velocimetry, which in their stereoscopic version can measure all three components of velocity fields, but are limited to one section of the flow. Today, despite the rapid development of three-dimensional particle tracking techniques using four (or more) cameras, holography still has many advantages. It can be adapted to complex experimental configurations where optical access is limited, and goes beyond the simple positioning of particles to simultaneously measure all their characteristics, from their size to information on their composition via their refractive index. However, holography comes up against a number of limitations. Measurement accuracy along the optical axis is often low with lensless in-line setups, due to the small numerical aperture. The density of particles that can be measured in a single acquisition is limited, which, like many other imaging methods, restricts it to dilute flows. Finally, in its simplest version, without additional image transfer optics, the measurement volume remains limited by the small size of the sensors. For these reasons, on-line digital holography remains essentially a laboratory technique. Nevertheless, it has strong development potential and is increasingly used by researchers and engineers, taking advantage of constant technological advances in sensors, in terms of size, resolution (ever-smaller pixels, down to 1 μm), dynamics (up to 16 real bits) and acquisition frequencies (several tens of kilohertz for images of several megapixels). This article describes on-line digital holography and its application to experimental fluid mechanics. The diffraction and light propagation phenomena on which the technique is based are reviewed in the first section within the framework of scalar optics. In the second part of the article, the most common optical set-ups and the various numerical reconstruction methods are described. The third...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference
KEYWORDS
3D imaging | Fluid mechanics | Digital holography | particle imaging
This article is included in
Physical measurements
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
On-line digital holography applied to fluid mechanics measurements
Bibliography
Websites
Online codes :
MATLAB code for online hologram simulation and reconstruction using the plane-wave spectrum method (Tatiana Latychevskaia and Hans-Werner Fink), https://www.mathworks.com/matlabcentral/fileexchange/59939-holography-with-plane-waves-inline-in-line...
Events
Congress:
Digital holography meeting applied to fluid metrology, five editions since 2010 – https://holophi5.sciencesconf.org/
Directory
Laboratories – Design offices – Schools – Research centers (non-exhaustive list)
The following is a non-exhaustive alphabetical list of French research teams using on-line digital holography for fluid mechanics measurements (laboratories working with off-axis fixtures are not listed).
COmplexe de Recherche Interprofessionnel en Aérothermochimie, UMR CNRS 6614
University...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference