Français
1. Objective and modeling
The first step is to formalize the problem in question mathematically: this is the subject of this section. After specifying the class of systems under consideration, the control objective is formulated and the two main approaches to meeting it are defined. The emulation approach is then pursued and a final complete model with both continuous-time dynamics specific to the physical system (between two successive transmission instants) and discrete instantaneous behaviors (corresponding to data transmission) is presented. The terms "transmission" and "sampling" are used interchangeably to designate the transmission of data between the system and its controller and/or the updating of the latter.
1.1 Objective
Consider the following multi-input linear time-invariant...
The Ultimate Scientific and Technical Reference
This article is included in
Control and systems engineering
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Objective and modeling
Transmission laws
Bibliography
Software tools
Hybrid Equations Toolbox v2.04 from Matlab, Mathworks.
Events
International Conference on Event-based Control, Communication, and Signal Processing
IEEE Conference on Decision and Control
Documentation – Training – Seminars (non-exhaustive list)
HEEMELS (W.P.), JOHANSSON (K.H.) and TABUADA (P.). – An introduction to event-triggered and self-triggered control. 51 st IEEE Conference on...
The Ultimate Scientific and Technical Reference
