3. Mechanical glass cutting
3.1 Principle
In the past, glass was cut using natural or synthetic diamonds. Today, we use a small-diameter cutting wheel made of very hard steel. These wheels are made of tungsten carbide and have a diameter of around 4.5 mm. They are mounted on the cutting head by means of a wheel holder.
When scribing with a tungsten carbide cutting wheel (with a V-shaped cutting edge), a small groove is formed on the surface of the glass under the influence of pressure, from which a crack propagates through the glass. This groove crosses the compression zone of the glass surface and, as the center is in tension, all that's needed is to break the sheet by pressing a sharp blow under the cut of the cutting wheel.
...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference
This article is included in
Material processing - Assembly
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Mechanical glass cutting
Bibliography
- (1) - BARTON (S.), GUILLEMET (C.) - Le verre : science et technologie. - Éditions EDP Sciences, p. 77-83 (2005).
- (2) - SCHOLZE (H.) - Le verre. - Institut du Verre, Paris, p. 42-44, p. 70, p. 163-165, et p. 172-174 (1974).
Also...
Directory
Manufacturers – Suppliers – Distributors
Companies specializing in cutting equipment:
Adler SA : http://www.adler-sa.fr
Bavelloni
Bottero SpA : http://www.bottero.com
Bystronic Lenhardt...
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
The Ultimate Scientific and Technical Reference