Français
5. Cutting methods
5.1 Automatic cutting with thumbwheel
5.1.1 Cutting monolithic glass
This is the most widely used cutting method. It is used for soda-lime silicate glass in thicknesses from 2 to 19 mm.
Until 1950, the operator, known as the "cutter", worked on a fixed table covered with a felt mat. He scribed with a diamond wheel mounted on a hand-held tool holder, while manual breaking was carried out with a ruler.
In the 1960s, the fixed table became a tilting table, equipped with...
The Ultimate Scientific and Technical Reference
This article is included in
Material processing - Assembly
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Cutting methods
Conclusion
Bibliography
- (1) - BARTON (S.), GUILLEMET (C.) - Le verre : science et technologie. - Éditions EDP Sciences, p. 77-83 (2005).
- (2) - SCHOLZE (H.) - Le verre. - Institut du Verre, Paris, p. 42-44, p. 70, p. 163-165, et p. 172-174 (1974).
Also...
Directory
Manufacturers – Suppliers – Distributors
Companies specializing in cutting equipment:
Adler SA : http://www.adler-sa.fr
Bavelloni
Bottero SpA : http://www.bottero.com
Bystronic Lenhardt...
The Ultimate Scientific and Technical Reference
