Français
5. Membranes and bulkheads bonded to the hull
The hull is contact-molded beforehand, then the frames and reinforcements are added.
It is very important to distribute the stresses over as large an area as possible, with local reinforcements, laminations and layering of graded laminated layers, and suitable design, as shown in figure 7 . Laminating enables L-shaped reinforcements to be produced, resulting in a good T-joint (figure 7 ).
The Ultimate Scientific and Technical Reference
This article is included in
Material processing - Assembly
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Membranes and bulkheads bonded to the hull
Deck to hull assembly
Bibliographical reference
The Ultimate Scientific and Technical Reference
