![](/assets/images/picto-drapeau-france-3a76576a5d60a512053b4612ab58dae5.png)
3. Control procedure
3.1 General
All control procedures must define :
the objective ;
operations to be carried out ;
tolerances ;
reference documents ;
any special devices to be used.
Depending on the nature of the installations and the requirements of the contract, this inspection may correspond to :
to a simple check of compliance with the contract;
an inspection linked to the verification of fundamental safety requirements;
to check that the lines are working properly....
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
![](/assets/images/logo-eti-286623ed91fa802ce039246e516e5852.png)
The Ultimate Scientific and Technical Reference
This article is included in
Hydraulic, aerodynamic and thermal machines
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Control procedure
References
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
![](/assets/images/logo-eti-286623ed91fa802ce039246e516e5852.png)
The Ultimate Scientific and Technical Reference