Français
2. General recommendations for all process categories
The risks involved in additive manufacturing depend on both the process used and the materials employed.
. The aim of this section is to present occupational risk prevention recommendations for each of the seven process categories
The Ultimate Scientific and Technical Reference
This article is included in
Safety and risk management
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
General recommendations for all process categories
Conclusion
Bibliography
Standards and norms
- Additive manufacturing – Design – Requirements, guidelines and recommendations. - NF EN ISO/ASTM 52910 - Mars 2020
- Additive manufacturing – Safety, health and environment – Requirements for metallic materials. - XP E67-006 - Juillet 2020
Regulations
Council Directive 89/391/EEC of June 12, 1989 on the introduction of measures to encourage improvements in the safety and health of workers at work (OJEC L. 183 of June 29, 1989, CELEX :31989L0391).
Directive 2014/34/EU of the European Parliament and of the Council of February 26, 2014 on the harmonization of the laws of the Member States concerning equipment and protective systems intended for use...
The Ultimate Scientific and Technical Reference
