Français
6. Checking equipment
6.1 Provisions common to all equipment
The plant manager must implement organizational measures as part of his company's prevention policy to :
maintain all equipment in a state of compliance, including in the event of modifications;
identify and remedy any damage likely to create a hazard.
Where equipment used for working at height is concerned, these provisions must be strictly observed, given the risks associated with the use of faulty equipment.
For some equipment, regulations require periodic or one-off checks to ensure that the equipment is in good condition. For equipment not covered by the regulations, it is up to the company to make the...
The Ultimate Scientific and Technical Reference
This article is included in
Safety and risk management
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Checking equipment
Websites
Standards and norms
- Moyens d'accès permanents aux machines : Partie 1 : Choix du moyen d'accès fixes entre deux niveaux Partie 2 : Plates-formes de travail et passerelles Partie 3 : Escaliers, échelles à marches et garde-corps Partie 4 : Échelles fixes - NF EN ISO 14122-1 à 4 -
- Temporary perimeter guardrails – Product specification, test methods - NF EN 13374 -
- Industrial plant components – Permanent means of access 013:...
Regulations
Labor Code
L. 4121-2 (formerly article L. 230-2)
R. 4141-3 (formerly article R. 231-34)
R. 4141-38 (formerly article R. 231-38)
R. 4323-55 (formerly article R. 233-13-19)
R. 4323-69 (formerly article R. 233-13-31)
R. 4323-90 (formerly article R. 233-13-37)
R. 4323-1...
The Ultimate Scientific and Technical Reference
