Overview
![](/assets/images/picto-drapeau-france-3a76576a5d60a512053b4612ab58dae5.png)
ABSTRACT
The development of a non-destructive measurement of the pressure and gas composition in a fuel rod is a highly beneficial innovation project for the nuclear industry. Its completion would make it possible to increase the number of measurements and thus improve our knowledge of the behavior of fuel products in the reactor, while reducing waste and radiological risks for those involved. The current collaboration between EDF and IES (Montpellier University / CNRS) aims to achieve usable measurements directly in EDF’s nuclear facilities, including new or slightly irradiated rods with low internal pressure.
Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.
Read the articleAUTHORS
-
Jean-Yves FERRANDIS: CNRS Research Engineer - IES (Institut d'Electronique et des Systèmes), UMR5214, University of Montpellier / CNRS, France
-
Rémi TOURNEUX: Nuclear Fuel Project Manager - EDF, Nuclear Fuel Division (EDF/DPNT/DCN), France
INTRODUCTION
Taking measurements on uranium fuel assemblies, directly in the deactivation pools of nuclear power plants, is a complex goal, but a useful one for multiplying measurements and applications effectively.
Today, in order to measure the pressure or internal composition of a rod's fission gases, it is necessary to carry out heavy operations that generate radiological exposure for those involved (extraction of the rod to be analyzed, transport of the rod in specialized packaging subject to approval by the French Nuclear Safety Authority, receipt of the rod in a specialized laboratory to analyze the gas contained inside, then disposal of the rod as waste).
Implementation directly in the deactivation pool would therefore make it possible to avoid heavy, costly and sensitive operations from a nuclear safety/radiological protection point of view, and reduce the production of nuclear waste.
In recent years, EDF, IES and probe manufacturer SONAXIS have therefore been working together to make progress towards this goal, which has involved substantial work to optimize signal processing and produce operational sensors that are sufficiently miniaturized for use in a fuel assembly bundle. Work was also carried out to demonstrate that it was possible to use the sensors without direct manual assistance in a configuration close to that of an assembly in a fuel deactivation pool. In particular, it was necessary to come up with a design for a prototype carrier that would enable the positioning and bearing force of the sensor on a rod to be controlled. Finally, different rod configurations, representative of the EDF fleet (tube thickness, springs, oxidation level), were tested and their impact on the measurement was quantified.
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
![](/assets/images/logo-eti-286623ed91fa802ce039246e516e5852.png)
The Ultimate Scientific and Technical Reference
KEYWORDS
fuel rod | non-destructive measurement | pressure | nuclear industry
This article is included in
Physical measurements
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Acoustic characterization of a gas in a uranium rod in a nuclear storage pool
Bibliography
Exclusive to subscribers. 97% yet to be discovered!
You do not have access to this resource.
Click here to request your free trial access!
Already subscribed? Log in!
![](/assets/images/logo-eti-286623ed91fa802ce039246e516e5852.png)
The Ultimate Scientific and Technical Reference