Article | REF: J6902 V1

Paper processes - Paper machines

Author: André LEMAÎTRE

Publication date: December 10, 2003

You do not have access to this resource.
Click here to request your free trial access!

Already subscribed? Log in!


Overview

Français

Read this article from a comprehensive knowledge base, updated and supplemented with articles reviewed by scientific committees.

Read the article

AUTHOR

  • André LEMAÎTRE: Engineer from the École Française de Papeterie de Grenoble (EFPG) - Doctorate in Automatic Engineering - Coordinator of the Consulting and Expertise Department at the Centre Technique du Papier (CTP)

 INTRODUCTION

The paper machine itself will be used, from a raw material (or pulp) prepared for this purpose (cf. ), to produce a continuous sheet of paper or cardboard, of a given width and corresponding to well-defined specifications (grammage, thickness, given physical and optical properties). Modern machines currently reach speeds of 1,800 m/min (newsprint), and even 2,200 m/min for special machines used for sanitary and household papers. Some machine manufacturers are looking to increase speeds up to 2,500 m/min, and several pilot paper machines are already running in excess of 2,000 m/min for light grades (newsprint). Machine widths can reach 10 m, but an increase in width is unlikely in the short term.

The paper machine consists of three main parts (figure 1 ):

  • the wet section, comprising the headbox and the production table. This is where the sheet is formed and drained, first by gravity and then by vacuum;

  • the press section, where the sheet is mechanically dewatered as much as possible;

  • drying, where the remaining water is thermally eliminated (evaporation).

On leaving the dryer, the sheet, at a moisture content of between 4 and 9% (by mass), is stored in reels using a rewinder. Before this final stage, which represents the end of the paper machine, the sheet can undergo a number of additional in-line treatments: coating, coating, smoothing, calendering, etc. All these operations generally add value to the paper. All these operations, which generally add value to the paper, can of course be carried out off-machine, on special installations: coaters, calenders, supercalenders.

The three main parts of the paper machine (according to Metso)
Figure 1  -  The three main parts of the paper machine (according to Metso)
You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource.
Click here to request your free trial access!

Already subscribed? Log in!


The Ultimate Scientific and Technical Reference

A Comprehensive Knowledge Base, with over 1,200 authors and 100 scientific advisors
+ More than 10,000 articles and 1,000 how-to sheets, over 800 new or updated articles every year
From design to prototyping, right through to industrialization, the reference for securing the development of your industrial projects

This article is included in

Wood and paper

This offer includes:

Knowledge Base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

Practical Path

Operational and didactic, to guarantee the acquisition of transversal skills

Doc & Quiz

Interactive articles with quizzes, for constructive reading

Subscribe now!

Ongoing reading
Paper processes