Français
2. Mechanical properties
2.1 Implementation criteria
Machining recommendations, which are scattered throughout a number of highly specialized publications, have been summarized in a number of tables based on basic documents produced by the technical teams at the Machinability Data Center (Metcut Research Associates Inc.) in the USA and CETIM in France, with a few additions provided by certain steel suppliers. The machining operations selected for this guide are as follows:
...
The Ultimate Scientific and Technical Reference
This article is included in
Studies and properties of metals
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Mechanical properties
Conclusion
Bibliography
Chemical composition and structure
Events
Moules et Outils 2007 and 2011, events organized jointly by A3TS and CEM every 4 years in October at the École des Mines d'Albi and subsequently reproduced in CEM newsletters. Next event in October 2015
Standards and norms
French and European standards. French Standards Association (AFNOR)
http://www.boutique.afnor.org/ , http://www.normadoc.com:
Standards NF EN ISO
- Aciers et produits en acier : position et préparation des...
Directory
Manufacturers – Suppliers – Distributors (non-exhaustive list)
Akers France SA, Chemin du Leidt, 57100, Thionville Tel. 03 82 82 23 00, Fax 03 82 82 23 01
Ascometal, Groupe Lucchini, Immeuble Le Colisée, 8 avenue de l'Arche, 92419, Courbevoie, Tel. 01 55 70 73 00, Fax 01 55 70 73 81...
The Ultimate Scientific and Technical Reference
