3. Technology modeling
Once the previous pre-sizing phase had been completed, all the converter parameters were defined, taking into account a number of technological elements:
the nature of semiconductors ;
close control circuit parameters ;
dimensioning of magnetic components ;
capacitor technologies.
However, even if the dimensioning models used in this phase are fairly close to the technology, these components still have to be built and installed in the converter, without the elements not taken into account in the pre-dimensioning calling everything into question. Fortunately, these additional imperfections, mainly linked to wiring imperfections, do not affect the same frequency ranges, and can even help to improve operation...
The Ultimate Scientific and Technical Reference
This article is included in
Conversion of electrical energy
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Technology modeling
Conclusion
Bibliography
Software tools
PSIM: Circuit simulation software https://powersimtech.com/products/psim/
InCa: Software for simulating parasitic elements in electrical interconnections based on the PEEC (Partial Element Equivalent Circuit) method http://www.cedrat.com/software/inca3d/
...Standards and norms
- Industrial, scientific and medical equipment – Radio interference characteristics – Measurement limits and methods, AFNOR - NF EN 55011 - 05-10
- Environmental Conditions and Tests Procedures for Airborne Equipment, RTCA, - DO160 - 06-07
The Ultimate Scientific and Technical Reference
