Français
2. Determining the thickness of rebated glazing
This paragraph applies only to glazing where the edge is held in place partially or completely around its periphery, in a rebate.
It does not apply to the calculation of the glued stabilizers themselves (for stabilizer thickness and dimensions, see § 4 ). It does, however, apply to the glazing supporting these...
The Ultimate Scientific and Technical Reference
This article is included in
The finishing and equipment of the building
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Determining the thickness of rebated glazing
Examples of thickness checks
Bibliography
Software tools
– GINGER-CEBTP [GLAZING-DECISION] [email protected]
– FFPV [XLGLACE DTU 39 – 2012]
– PI DEVELOPPEMENT SARL Le Fraysse 81440 LAUTREC [PI-VITRAGES 5.4] http://www.pisarl.com
Standards and norms
- Glazing and metalwork – Memento Calculating glazing thicknesses - NF DTU 39 P4 -
- Eurocode 1 – Actions on structures – Part 1-4: general actions – Wind actions - NF EN 1991-1-4 -
- Eurocode 1 – Actions on structures – Part 1-4: General actions – Actions du vent/National appendix - NF EN 1991-1-4/NA -
- Eurocode 1 – Action on structures – Part 1-3: General actions – Snow loads - NF EN 1991-1-3 - ...
The Ultimate Scientific and Technical Reference
