Article | REF: IN53 V1

Adaptive control of the thermoplastics injection process

Authors: Jean-Étienne FOURNIER, Nicolas HAVARD, Marie-France LACRAMPE, Marc RYCKEBUSCH, Patricia KRAWCZAK

Publication date: April 10, 2006

You do not have access to this resource.
Click here to request your free trial access!

Already subscribed? Log in!


Français

5. Effect of piping system on mass and dimensional stability

Typical evolution of pressures measured during filling of the specimen mould for the different piping modes used
Figure 2  -  Typical evolution of pressures measured during filling of the specimen mould for the different piping modes used

Given the concept used, advanced control modes systematically result in a longer effective holding pressure application time than...

You do not have access to this resource.

Exclusive to subscribers. 97% yet to be discovered!

You do not have access to this resource.
Click here to request your free trial access!

Already subscribed? Log in!


The Ultimate Scientific and Technical Reference

A Comprehensive Knowledge Base, with over 1,200 authors and 100 scientific advisors
+ More than 10,000 articles and 1,000 how-to sheets, over 800 new or updated articles every year
From design to prototyping, right through to industrialization, the reference for securing the development of your industrial projects

This article is included in

Plastics and composites

This offer includes:

Knowledge Base

Updated and enriched with articles validated by our scientific committees

Services

A set of exclusive tools to complement the resources

Practical Path

Operational and didactic, to guarantee the acquisition of transversal skills

Doc & Quiz

Interactive articles with quizzes, for constructive reading

Subscribe now!

Ongoing reading
Effect of piping system on mass and dimensional stability