Français
8. Checking machines and hardness blocks
For hardness measured by indentation, there are no fixed natural points on which to establish an absolute hardness scale. It is necessary to take into account all the factors that can influence the value given by a machine. This leads to specific recommendations for each test method, and to specific checks for each type of machine (standards NF EN ISO 6506-2, NF EN ISO 6507-2, NF EN ISO 6508-2, NF EN ISO 14577-2 respectively for Brinell, Rockwell, Vickers and penetration testing machines). These standards enable us to obtain mutually comparable measurements with equipment tested in this way.
Hardness testing machines are calibrated either by direct methods or by indirect methods using reference blocks.
With the first methods, the various components of the measurement chain need to be calibrated successively: measurement of applied force,...
The Ultimate Scientific and Technical Reference
This article is included in
Friction, wear and lubrication
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Checking machines and hardness blocks
Bibliography
Standardization
NF EN ISO 6506-1 October 1999
Metallic materials – Brinell hardness test – Part 1: Test method
NF EN ISO 6506-2 October 1999
Metallic materials – Brinell hardness test – Part 2: Verification and calibration of testing machines
NF EN ISO 6506-3 October 1999
Metallic materials – Brinell hardness test...
Manufacturers Suppliers (non-exhaustive list)
Testwell http://www.testwell.fr
Zwick http://www.zwick.fr
SOMECO http://www.someco.fr
Wolpert HCH Reimmann AG machine...
The Ultimate Scientific and Technical Reference
