Français
8. Testing (RCC-M)
Fatigue tests on mock-ups representative of the equipment can be used to justify the installation, or part of it, if the primary and primary plus secondary stress equations are verified.
The number of cycles and the loading amplitude to be applied during the tests must be increased respectively by the coefficients K TN and K TS , determined themselves from the coefficients K s and K n and the principle set out in figure 37 .
Point D (figure...
The Ultimate Scientific and Technical Reference
This article is included in
Physics and chemistry
This offer includes:
Knowledge Base
Updated and enriched with articles validated by our scientific committees
Services
A set of exclusive tools to complement the resources
Practical Path
Operational and didactic, to guarantee the acquisition of transversal skills
Doc & Quiz
Interactive articles with quizzes, for constructive reading
Testing (RCC-M)
Conclusion
Bibliography
Software tools
PIPESTRESS version 3.8.0
Mathcad 2001
Regulations
American Society of Mechanical Engineers ASME NB-3000 2013 Edition
Rules for the Design and Construction of Mechanical Equipment for PWR Nuclear Islets RCC-M B 3000 2012 Edition
Structural Eurocodes – Bases de calcul des structures NF EN 1990
Eurocode 1 – Actions on structures NF EN 1991-1-3 (snow) and NF EN 1991-1-4 (wind)
The Ultimate Scientific and Technical Reference
